deschoolmeester
11-03-2004, 04:41 AM
****o,
i've just recently started using primopdf but looks very good.
One thing though: when printing from Bricscad (intellicad - autocad clone) with a custom paper size bigger than 1350mm length (900 width) the print gets stretched longitudinal to approximately twice its size: so it no longer fits on a page to which it should fit.
It's strange because when I select a paper size of 1350mm or less (same width) the print is not strechted (but then the print doesn't fit on the page because the selected dimensions of the page is to small).
So I guess something goes wrong when selecting a paper size bigger than 1350mm.
Does anybody has the same experience (Autocad,...)?
Thanks in advance
Bart
i've just recently started using primopdf but looks very good.
One thing though: when printing from Bricscad (intellicad - autocad clone) with a custom paper size bigger than 1350mm length (900 width) the print gets stretched longitudinal to approximately twice its size: so it no longer fits on a page to which it should fit.
It's strange because when I select a paper size of 1350mm or less (same width) the print is not strechted (but then the print doesn't fit on the page because the selected dimensions of the page is to small).
So I guess something goes wrong when selecting a paper size bigger than 1350mm.
Does anybody has the same experience (Autocad,...)?
Thanks in advance
Bart